Hoe kan ik de vochtadsorptie op FR4 PCB minimaliseren?

Although the adsorption of moisture by FR4 is quite low, what is the best way to minimize it or eliminate it completely?

Adsorption is a chemical process that occurs on the surface and can affect surface resistivity. Since you are talking about PCB mass, it sounds like you are actually talking about moisture absorption which is diffusion into the bulk of the material.

  • If there are any fixing holes, it will be impossible to eliminate them completely.
  • I have some products where the use of this sealant is mandated (they are in ship-board aircraft). I only mention this to show there are solutions, if there is a requirement for complete sealing.
  • Simply covering most of the PCB with solder mask will reduce the absorption of moisture.
  • From a system point of view, other than the bare PCB, it would be important to avoid components that absorb moisture- which would include plastic-packaged parts, but especially polyamide (Nylon) fasteners etc. which can absorb an enormous amount of moisture (as much as 10%)- enough to cause large dimensional changes as well as mass changes.

Lees verder: Een uitgebreide gids voor FR4 thermische geleidbaarheid

#PCB-productie

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

How should I handle wet PCBs?

A batch of PCB got wet in warehouse due to roof linking. Too terrible to shoulder the lost. How can I do to rescue these wet PCBs? Or to minimize the damage?

Is solder mask a valid electrical insulator?

There is a copper pour over the entire top of the my PCB, which is part of GND net. It turns out that the surface mounted 1W LEDs I’m going to use have the heat slug connected internally to the LED’s +ve terminal. Can I rely on the solder mask to insulate the +ve voltage (~3V ish) from GND? Long term?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven