Is solder mask a valid electrical insulator?

There is a copper pour over the entire top of the my PCB, which is part of GND net. It turns out that the surface mounted 1W LEDs I'm going to use have the heat slug connected internally to the LED's +ve terminal. Can I rely on the solder mask to insulate the +ve voltage (~3V ish) from GND? Long term?

Nee, I would not rely on a solder mask as an insulator, because it is very thin and can be nicked easily.

The key issue is going to be how to properly heat sink the LED without a good thermal connection to the heat slug. High-power LEDs usually want the heat slug soldered or thermally epoxied to a heatsink. This can be PCB copper, but since you stated that the PCB copper is connected to the GND net you can’t connect to it.

Lees verder: LED PCB-assemblage

#PCB Assembly #PCB Design

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

Kan ik een printplaat maken zonder grondvlak??

Recently we are developing a portable device which should be very tiny and light. In terms of PCB design, I am thinking whether it is a good idea to exclude ground plane to minimize the product size.

How can I connect my small PCB with sensor to the bigger PCB?

My small PCB is mounting a very sensitive fragile sensor on the top surface that has to be wire bonded to the PCB, so I am trying to design a smaller PCB that can be surface mounted to the bigger PCB. How can I get some kind of thin footprint for interconnecting the two PCB boards?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven