PCB testing methods during manufacturing and assembly?

We plan to visit factory next week. Could we know more about how many basic PCB testings in EMS field?
  1. VISUAL INSPECTION
  2. IN-CIRCUIT TESTING (ICT)
  3. FLYING PROBE TESTING(FPT)
  4. AUTOMATED OPTICAL INSPECTION (AOI)
  5. AUTOMATED X-RAY INSPECTION(AXI)
  6. FUNCTIONAL TESTING (FCT)
  7. BURN-IN TESTING

#PCB Manufacturing #PCB Assembly #PCB Testing

https://www.youtu.be/4gLra_RI-wg?si=lpPBd0qUPqNvxcCY

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

How to handle feedline of bluetooth PCB connected to a 2.4GHz chip antenna?

I’m making a 4 layer PCB prototype that uses a bluetooth mcu connected to a 2.4GHz chip antenna. I’m thinking about what to do with the feedline, whether it should be buried on one of the middle layers, or left on the top layer. To get a 50 ohm line, should I choose top layer with 13-mil width or buried miccrostrip with 7-mild width?

Waarom zijn RF-PCB's moeilijk te ontwerpen??

I am a project procurement. Kort geleden, Our project is to develop a television. Of all the materials supply, PCB was the slowest one. And even our engineer took part in the discussion with PCB supplier to push them. Is it really hard to make a RF PCB?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven