Wat moeten we controleren voordat we een PCB-ontwerp vrijgeven??

After making efforts in a period, I finally finish my PCB design. Next step is releasing them to factory for production. To be honest, I don't want any mistake on my file which may interrupt further prodution process. So what points should I pay attention when I double-check my design?
  • Check that what you want can be manufactured. Apply design rules and check indicated violations.
  • Check the layers stack.
  • Check the board in 3D view to clean any obvious errors.
  • Print 3D model and check with your mechanical designers.
  • Check the via diameters. Unify some of the hole diameters. Add more stitching to the polygons. Check that you have tenting where you want the solder mask cover. Modify paste rules to remove paste from test pads. Replace non-plated holes with board cutouts. Generate keep out layer.
  • Check layout in single layers and in pairs.
  • Generate and check Gerber layers of the single circuit.
  • Check Gerber layers of the panelized board.
  • Send the files to yourprocurement. Make sure that your attached comments and contact details are provided with the order and not removed by your purchasing guy. Get ready for the queries. Answer them back.

https://www.youtu.be/E-F1Z2kP9Cs?si=zBN9yxZAkpCFUaGA

#PCB-assemblage #PCB Design

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

Why should we bake bare PCB?

The assembly note states: Bake bare PCBs in a clean and well ventilated oven prior to assembly at 125*C for 24 uren. Why is this necessary?

Can I design SMD elements on the back of THT?

I’m designing a PCB right now and found out I can save a lot of space using the back of THT elements. Is it legit to design like that? Are there any problems that might occur?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven