The question does not specify the expected number of flexing cycles across the device lifetime. For applications where the FPC will be flexed just once at installation, such as connections between the LCD panel and attached backpack controller board, pretty much anything goes. At worst, infantile death of the FPC if it happens, will be detected in a test run.
Assuming multiple flexing cycles:
The location of the via inherently becomes a weak point. Given that flexing already creates stress on the copper layers, this is a conduction breakage waiting to happen. You will notice that if there ever are vias on FPC, they are found on the parts unlikely to bend.
The copper used must also be the thinnest possible, to minimize risk of fracture. This means 1 ounce copper, or thinner even, if the application can stand it.
Read More: Flex PCB Design- How to Make It A Success
#PCB Manufacturing #Flex PCB
Shenzhen, China (November 14, 2025) — MOKO Technology, a leading electronics manufacturing services provider, successfully…
PCB prepreg and PCB core are two of the most important materials in PCB manufacturing.…
Have you ever see a circuit board that you can actually see through? That is a…
Impedance matching has become a cornerstone of the signal integrity in the realm of high speed PCB…
It is important to learn how to clean a circuit board properly if you’re working…
When designing PCBs, selecting the appropriate type of holes for fasteners is crucial. And much…