Yes unless the design is optimized. If the PCB is an automotive electronics solution, it should not only withstand slight shocks, it should also withstand vibrations and some harder shocks.It is advisable to use only those connectors designed for such cables and don’t solder the cable at all. There are additional strain-relief parts for those connectors and cables.
O, you can ask for design tips from your assembly house to ensure successful mass production.
#Progettazione PCB
I have a PCB that was poorly designed and there is a ground pad that is too close to a signal pad. Di conseguenza, the signal pad on the surface mount component will short to ground. I was looking to use some ink or other material to cover the ground pad. The pads are too small to fit Kapton tape. Are there any standard materials used to cover PCB SMT pads?
I have designed a power supply card using V7805-2000. Copper thickness is 70 micron, board size is 5 cm × 5 cm. When this underwent vibration test the regulator came off, broken into two pieces(regulator leads are in the holes). How is it going?
When I sourcing PCB online, I found some of them are with heavy copper. Why would the designer use copper for PCB?
Mantenere la qualità del design PCB ad alta velocità dal driver al collettore sul PCB non è un compito facile. Uno dei più test
Lo spazio dei circuiti stampati (PCB) è spesso un premio nel moderno, design di prodotti compatti, l'ottimizzazione delle dimensioni del PCB è diventata una considerazione essenziale.
Una domanda comune quando si progettano circuiti stampati complessi per l'elettronica avanzata è se utilizzare vie impilate o sfalsate per instradare le connessioni tra gli strati.
Contattaci
Copyright ©2024 Tecnologia MOKO | Il tuo partner EMS di fiducia Guangdong ICP n. 15085690