Why do all the ground leads short outs beteween each other after Packing Virtex-4 via BGA?

After We have assembled the Virtex-4 FPGA BGA package on our custom design PCB, we check for short circuits between all power grounding and they shows short cut between each other. Please tell us about any process for debugging this issue.

November 16, 2023

Check you CAD database.
Test you custom PCB before BGA packing.
Check every pin on the board.
Consider if Virtex-4 is too old to run with your circuit.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How can I fix my “D” key that sometimes isn’t responding when I click on it?

My mechanical keyborad is brand new so I cannot find where the culprit is. How I fix the key?

Oliver Smith October 11, 2023

Does anyone have any experience using zero-ohm resistors in an RF signal path to select antennas?

I’ve typically used RF switches for this purpose, but that’s also when it was necessary to allow the antenna selection to be changed “in the field”. But for cases where the antenna selection is a manufacture-time option, I’m considering simple zero-ohm resistors.

Oliver Smith December 6, 2023

How does PCB manufacturer work for double sided SMT assembly with BGA’s?

How does a conventional board house deal with the issue of reflow during PCB component assembly with BGA’s on both sides of the board?
Are two different solders used (like regular lead free SAC305 and a low temp?)

Oliver Smith November 6, 2023

Why do all the ground leads short outs beteween each other after Packing Virtex-4 via BGA?

Oliver Smith

Oliver Smith

What Others Are Asking

How can I fix my “D” key that sometimes isn’t responding when I click on it?

Does anyone have any experience using zero-ohm resistors in an RF signal path to select antennas?

How does PCB manufacturer work for double sided SMT assembly with BGA’s?

Read Detailed Advice From Blog Articles