Can I design SMD elements on the back of THT?

I'm designing a PCB right now and found out I can save a lot of space using the back of THT elements. Is it legit to design like that? Are there any problems that might occur?

November 24, 2023

If you want to meet CE requirements for noise immunity and emissions, a two-layer board would help a lot.

Generally speaking, there is no problem with putting components on both sides of the board, in the same place. If you had a two (or more) layer board, you’d probably want to put a ground or power plane between them. However, you can’t do that with a single-layer board. So you should watch out for a fast digital chip interfering with an analog circuit. It would be inadvisable.

For example, put a microcontroller on one side and a high input impedance buffer on the other. But putting decoupling caps opposite the chip is probably a good plan.

#PCB Design

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How can I fix the PCB to the mechanical structure?

I designed a PCB with an imaging sensor that is mechanically coupled to a lens assembly using four 2-56 screws. I’m noticing that even though the screws are holding the board tightly against the mechanical structure if I flick or lightly knock the the assembly the image “moves”. I’m hoping to get a few suggestions for ways to fix the PCB to the mechanical structure. Any suggestions for adhesives or the like? Something else?

Oliver Smith November 21, 2023

Why are RF PCBs hard to design?

I am a project procurement. Recently, Our project is to develop a television. Of all the materials supply, PCB was the slowest one. And even our engineer took part in the discussion with PCB supplier to push them. Is it really hard to make a RF PCB?

Oliver Smith September 20, 2023

What kinds of test is suitable for low volume PCB order?

I’ve ordered fabrication and assembly of small PCB batches (100pcs) a couple of times already. Each time the factory asked me if I want to do test on the PCB. But I don’t what to do about it. And I test them by myself. Then, the result of the testing is unacceptable with 15% soldering problems. So bad. I think I will ask the supplier to test them before delivery.

Oliver Smith November 16, 2023

Can I design SMD elements on the back of THT?

Oliver Smith

Oliver Smith

What Others Are Asking

How can I fix the PCB to the mechanical structure?

Why are RF PCBs hard to design?

What kinds of test is suitable for low volume PCB order?

Read Detailed Advice From Blog Articles