Can I make a PCB without a ground plane?

Recently we are developing a portable device which should be very tiny and light. In terms of PCB design, I am thinking whether it is a good idea to exclude ground plane to minimize the product size.

September 25, 2023

It depends. For high-speed logic or RF circuits, a ground plane is necessary. For others, ground or power plane is not required.

You should, however,

Make sure that the traces are as wide as possible, particularly for the power, ground or other high-current connections.
Ensure fatter traces are more reliable.

#PCB Design

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Approximately how many PCB layers would be needed to route a 1088 pin BGA IC?

I am designing a PCB with 1088 pin BGA IC. Haven’t handle such a big IC. I am not sure the best amount of layer.

Oliver Smith October 20, 2023

Is solder mask a valid electrical insulator?

There is a copper pour over the entire top of the my PCB, which is part of GND net. It turns out that the surface mounted 1W LEDs I’m going to use have the heat slug connected internally to the LED’s +ve terminal. Can I rely on the solder mask to insulate the +ve voltage (~3V ish) from GND? Long term?

Oliver Smith December 7, 2023

Are SMT components bad for high voltage applications?

Many assembly factories are asking for SMT jobs, while I think through hole would be a better option for a high voltage application. Before the high voltage project is started, we need to make a call on SMT or Through hole parts. Is there a study on this?

Oliver Smith November 22, 2023

Can I make a PCB without a ground plane?

Oliver Smith

Oliver Smith

What Others Are Asking

Approximately how many PCB layers would be needed to route a 1088 pin BGA IC?

Is solder mask a valid electrical insulator?

Are SMT components bad for high voltage applications?

Read Detailed Advice From Blog Articles