What is the proper zero orientation for a SMT LED?

According to IPC-7351, the cathode should be on the left for a molded diode. However, when I use component wizard of my suppliers to create a diode, it places the cathode (K) on the right. Does it depend on the manufacturer? How does the assembly house know which way is correct?

November 23, 2023

We prefer cathode on the left, as per the standard, but typically rely on silkscreen or customer input to determine the proper orientation.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Is there any problems if I change 0805 too 0402 surface mount or smaller?

In order to reduce the size of a PCB, I will probably have to use smaller SM components. I currently use mostly 0805 passives, and am thinking about going to 0402 or smaller. Apart from power dissipation considerations, any pitfalls I should be aware of when making the transition?

Oliver Smith December 12, 2023

How do components not get knocked off or fall off during reflow?

Last week we visited a PCBA factory. We were looking at reflow ovens. A lot of them have a metal conveyor belt the boards sit on. On a double sided board, when you put the board on the metal belt, won’t the metal belt knock components off as they are only held on by paste?

Oliver Smith November 6, 2023

How do you test a washing machine control board?

Washing machine does not work. Since it just bought one years ago, the components in it is not old, I think. So I want to check it from its PCB. Any tips on this?

Oliver Smith October 20, 2023

What is the proper zero orientation for a SMT LED?

Oliver Smith

Oliver Smith

What Others Are Asking

Is there any problems if I change 0805 too 0402 surface mount or smaller?

How do components not get knocked off or fall off during reflow?

How do you test a washing machine control board?

Read Detailed Advice From Blog Articles