How can I manage the firmware development precess?

I ordered PCBA for IoT device and received the hardware product with good quality. However, there is a process I ignored before - firmware development based on the hardware. How should I move on?

PCB Assembly
October 17, 2023

Although PCBA factory only handles hardware, you can still ask them to give extra attention to assist your software& firmware engineer in fulfilling the firmware development. A good PCBA factory might have an open attitude to help you as a sophisticated hardware factory can do. They are capable of

Take care of PCBA design when fitting the requirement of your firmware engineer.
Help test the PCBA performance again after firmware is done if you are worried.
Keep your firmware design in secret.
Provide useful specifications of the PCBA so as to help your firmware development if you required.

#PCB Assembly #IoT #Aftersales

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Do you have the self-owned factory,or you’re a trading company?

Hello, we have never visited your company. Could you please tell if you are trading company or self-own factory? It will affect the difficult level of our supply chain management.

Oliver Smith November 9, 2023

How close is the soldering joint for PCB?

E: The prototype provided by the supplier is good, but I found some solder joints are close to the PCB. Actually, how much width would be better?

Oliver Smith October 31, 2023

Should I mount AC DC converter on PCB as a through-hole component, a surface-mount component, or have a header that this component is plugged into?

I need to figure out how to physically mount the following AC-DC converter to a PCB to be used as part of a regulated power supply. The pin height is min 3.0 mm.

Oliver Smith December 12, 2023