Schematics don’t do you much good on today’s high-tech electronics. Most high-tech electronics nowadays use custom chips or FPGAs so a schematic that shows all the signals going in and out of a magic proprietary chip won’t do you any good.
A lot of lower-tech components that perhaps use discrete parts, relays, discrete resistors, etc. do have schematics on the inside of the case or available online.
Read More: PCB Design
#PCB Design
I know the paste mask layer is also called the stencil layer. It’s only used for assembly. I want to know if the paste mask layer (both top and bottom layer) is necessary for through hole components. For SMD components I know the paste mask layer is required to solder the components. Is it necessary for through hole components?
I am working on a project that uses small Bluetooth low energy (BLE) beacons to track important items. Is there a way to connect two antennas to a single BLE module that could either listen/broadcast on both antennas or multiplex between the two? Or any other idea?
I’m designing a new PCB where I have a whack of connectors that have to line up with the metalwork. There are some problematic connectors. All 4 pins are round. I want to have the holes as small as possible while allowing for good solder adhesion over the full length of the pin. I’m looking for guidance on how much clearance around the component lead I should have in order to get good solder wetting and adhesion.
Markets
Contact Us
Copyright ©2025 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号
