Is it true that PCB antennas can be tuned by only changing their length?

My PCB antennas fail to achieve resonance, though I have changed their length. Our new product project is obstructed due to this problem now. Are there any good solution else?

November 14, 2023

No. The basic PCB antenna starts out as being a length of trace along a portion of the board where there is no ground plane on the layers below. If the available simple length is not enough to achieve resonance, several approaches can be used.

One is to zig-zag the trace to increase its effective length.
Another is to add a small chip inductor in series with the feed to the trace.
Still another is to add some capacitive end-loading at the far end of the antenna trace.

#PCB Design

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Is there a reason an 0805 resistor would have a different land pattern than an 0805 capacitor?

My PCB design software comes with some libraries that include some common components, like chip resistors and capacitors. I have noticed, however, that the footprint land pattern for the 0805 resistor is not identical to the 0805 capacitor. Is there a “best standard”? IPC-7351, IPC-SM-782, or what?

Oliver Smith December 12, 2023

How can I solder an SMD component with a pad on the bottom?

I am getting a PCB manufactured for a project that I am working on. One of the parts, the A4950 motor driver, has a “pad” on the bottom, which is meant to be soldered to GND of the PCB for thermal dissipation. I was thinking about the prototyping, and I am unsure how I would go about (using a soldering iron), soldering the pad on the bottom.

Oliver Smith December 11, 2023

What is an average CPH speed for hand SMD assembly?

What would be the average speed of assembling surface mount components on to a PCB for an experienced person? Assuming they have desk that is correctly set up (pick and place station) and the PCB has solder paste already applied.

Oliver Smith December 13, 2023

Is it true that PCB antennas can be tuned by only changing their length?

Oliver Smith

Oliver Smith

What Others Are Asking

Is there a reason an 0805 resistor would have a different land pattern than an 0805 capacitor?

How can I solder an SMD component with a pad on the bottom?

What is an average CPH speed for hand SMD assembly?

Read Detailed Advice From Blog Articles