I would like some boards on a panel to have different parts assembled while others are not assembled. How can I place this order?

We would like to assembly the smart chip by ourselves because and then ensure the wifi pairing. Any cautions when we place the order to factory to assembly extra part?
  • Remark your special requirement in the order.
  • Detail and explain your requirements in the email. It would be better to show pictures to make it clear.
  • If necessary, hold a meeting to promote communication, including making prototypes, finished products of this order and delivery.

Read More: Lifecycle Management Service

#PCB Assembly

Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.
Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

What Others Are Asking

How can I fix the PCB to the mechanical structure?

I designed a PCB with an imaging sensor that is mechanically coupled to a lens assembly using four 2-56 screws. I’m noticing that even though the screws are holding the board tightly against the mechanical structure if I flick or lightly knock the the assembly the image “moves”.  I’m hoping to get a few suggestions for ways to fix the PCB to the mechanical structure. Any suggestions for adhesives or the like? Something else?

Why are power supplies almost always made using through hole components?

Every computer PSU I’ve taken apart uses through hole components, though occasionally (not in all cases) surface mount components are found on the bottom. Don’t these have to be hand assembled? If so, why are they still doing this? even though labour costs are low in China, it still must cost less for a machine to pick and place SMT stuff.

Read Detailed Advice From Blog Articles

Scroll to Top