3 Layer PCB

Even Layers PCB Is Common, But Odd PCB Still Exists: 3 Layer PCB

A Tri-layer or 3 layer PCB is not very common and rarely found in the market. Most people prefer using the plural layers like 4 layers, 8 layers, and 16 layers PCBs. Sometimes electronic gadgets need a particular layer stack up to give the expected performance, and other times, the PCB designer plans to save expenses by using a 3 layer PCB board instead of a 4 layer PCB.

These multilayer PCBs have single or numerous conductor patterns inside their board, and it increases the available area for wiring. By gluing or laminating many two-sided circuit boards with insulating layers between them. Mostly the 3 layers printed circuit board is used because they give the perfect level of complexity for numerous resolutions. However, the capacity can be changed depending on the gadget.

How A 3 Layer PCB Is Stacked Up

Once you have decided on the number of the layers, you need to decide the stacking up or arrangement of these layers. Some ethical rules of its stack-up are:
For tight coupling, place signal layers next to the internal layers.
It is good not to have two signal layers adjacent to one another.
Route high-speed on least thick micro-strips.
Ground and power layers should have the least spacing between them.
Make the stack up symmetric from the upper layer to the bottom layers inward.

The Feature of 3 Layer PCB

Below are some highlights:
1. It reduces the weight of the whole machine and can make the entire machine miniaturization if used with the integrated circuit.
2. It decreases the component welding points, which help to reduce the failure rate.
3. The warm grounding place is introduced to decrease the local heat and improves the functionality of the device.
4. It reduces the spacing of components, minimizes the signal transmission path, and enhances the wiring density.
5. It reduces the signal distortion of the circuit with the help of the shielding layer.

Alternatives of 3 layer PCB

If you failed to find a 3 layer circuit board and you’re looking for an option, you can use a 4 layer PCB. It will cost a little extra, but it will surely do the work for you.

Moreover, you can also use point-to-point construction and wire wrap. Both of these things were famous at a time, but they are used very less nowadays.

PCBs need extra design effort to make or design the circuit. However, assembly and manufacturing can be computerized. There is specially designed CAD software available to do much work on the layout of the PCB.

The mass-producing circuits with PCBs are faster and cheaper with alternative wiring ways, as components are wired and mounted in one operation. Many PCBs can be easily fabricated at once, and you don’t have to work on the layout every time. You can also make PCBs manually, but they’ll have less benefit.

Find MOKO Technology For Your 3 Layer PCB Fabrication Needs

If you’ve been looking for a 3 layer PCB manufacturer for your devices’ requirements, you can always find MOKO Technology. Our PCBs are considered the best because of our engineers can offer you optimized PCB design as your requirement, and with our strict quality control system, you can never worry about the quality!

Scroll to Top