Home » Questions » PCB Assembly » Can I use normal PCB, such as office fan PCB, in mining fan?
Not advisable. Office fan PCB is originally designed for household use, so its performance meets a moderate level. If you use it for mining, it is not able to shoulder the workload and lifespan will shorten due to overwork. You can ask your supplier to recommend other fan PCB which is good at serving mining.
Read More: Air Conditioner PCB Board: A Comprehensive Guide
#PCB Assembly #Consume Electronics
I have some PCBs that were wave soldered but the vias still remain open, they are not filled nor plugged form what I can see. I do not see any solder on the annular rings of the vias either. How do they go about doing so?
That is my first time asking an assembly house to produce 200 units of a PCB (and not the usual 3 or 5 PCBs). The assembly house came back to me saying that the testability of the board was bad and that they need to have 1.2 mm pads on the bottom side of the PBC for all nets… They require such large pads because beds of nails are a much more economical option than flying probe for 200-400 units since they can do it in-house. Is adding 1.2 mm pad on ALL nets common practice for PCB?
I received the PCB design file from supplier. There are some teardrops, which I have seldom seen. Why are there teardrops on the PCB design?
What Is Turnkey PCB Assembly？ Turnkey PCB assembly refers to a service that PCB manufacturers take care of all aspects of your PCB project, including
PCB controllers enable the smarts in electronics of all types, from tiny wearables to industrial robots. These ingenious chips act as the brains of countless
Nowadays, people’s life is inseparable from electronic products. And printed circuit boards, as the brain of electronic products, their demand is also increasing correspondingly. As
Electronic Manufacturing
Contact Us
Copyright ©2022 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号
