Is it ok to call all the chips with alphanumeric labels BGA (ball grid array)?

Some ICs have their pins labelled only with numerical values and some use alphanumeric labels. I want to know what is the correct naming term for these cases. Is it ok to call all the chips with alphanumeric labels BGA (ball grid array)? And for chips with only numeric pin labels the chip should be called DIL (dual in line)?

PCB Assembly
October 26, 2023

Typically ICs with pins on the edges have numbered pins. That’s DIL, but also QFP, DFN and even SOT23. You start at the pin 1 marker and follow the contour. IIRC PLCCs have their pin 1 in the middle of one of the sides, but normally pin 1 is one of the corners.

You’ll see alphanumeric pin IDs whenever you’ve got some kind of grid, where there could be confusion about which are rows and which are columns. Usual suspects are BGA, PGA, and variants like WSP (WaferScale Packaging).

#PCB Assembly

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How do I use two antennas with a single Bluetooth module? (BLE repeater)

I am working on a project that uses small Bluetooth low energy (BLE) beacons to track important items. Is there a way to connect two antennas to a single BLE module that could either listen/broadcast on both antennas or multiplex between the two? Or any other idea?

Oliver Smith December 7, 2023

What’s the meaning of “CR” marked on the PCB?

Receive the PCB prototype from supplier. And see a CR mark on the board. What does it mean? Is it related to quality control?

Oliver Smith November 15, 2023

Which soldering iron tip should I use?

All of the soldering I’ve done to this point has been with through-hole components. I hope to move up to some smaller surface-mount parts at some point in the future. I’ve got a Weller WES51 soldering station. There is a large number of ET series tips available. How do I choose the right tip for the components I’ll be working with?

Oliver Smith December 13, 2023

Is it ok to call all the chips with alphanumeric labels BGA (ball grid array)?

Oliver Smith

Oliver Smith

What Others Are Asking

How do I use two antennas with a single Bluetooth module? (BLE repeater)

What’s the meaning of “CR” marked on the PCB?

Which soldering iron tip should I use?

Read Detailed Advice From Blog Articles

SMD Soldering: A Step-By-Step Guide

Why Choose PCB Assembly in China?

A Guide to PCBA: Definition, Types, Applications, and Process