The GL5506 has a significantly lower resistance for a given amount of light compared to the GL5516 AND, in dark conditions, the resistance of the GL5516 is significantly higher in resistance (as you would expect).
Read More: Consumer Electronics
#PCB Design
My small PCB is mounting a very sensitive fragile sensor on the top surface that has to be wire bonded to the PCB, so I am trying to design a smaller PCB that can be surface mounted to the bigger PCB. How can I get some kind of thin footprint for interconnecting the two PCB boards?
In common, I use 2 ounce copper as rule for all my PCBs. On a recent board, I am using a 0.5mm pitch, relatively large micro, and noticed the pads aren’t very flat. Assembly went fine with the protos, but I’m wondering if 1 once copper would provide for a flatter landing service. Any advice on assembly reliability related to copper thickness for such devices?
I’m trying to decide whether to order components direct from manufacturers in China or from distributors in the US. If I have to test each component either way, I’m not sure if it’s a counterfeit, especially when prices are 100x more expensive from distributors.
Fiducial marks, also known as fiducials, are small copper markers printed on PCB that serve as visual reference points during assembly and inspection, allowing automated
As printed circuit boards become smaller and faster, controlling impedance is crucial for managing signal integrity. With circuits operating in the GHz range, even signals
You are here because you want to learn about high frequency PCB design. This guide explains in detail different factors having an influence on high
Electronic Manufacturing
Resources
Contact Us
Copyright ©2024 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号