How do I protect myself when testing a PCB that involves an AC line?

I have received PCB samples containing AC line. Test is indispensable process on my side to ensure its quality and function. But is AC line dangerous? How do I protect myself during testing?

PCB Design, PCB Testing
November 30, 2023

Use residual current device. You will still get a large jolt if you touch the wires, but the RCD will protect your life.
Usepower tools outside: it did trip several times, and it turned out the extension cords had water inside the sockets, that kind of thing. It’s a nice safety feature.
Tape some insulating plastic sheet on the back of the PCB over the high voltage bits, if you only want to probe the low voltage side of the PCB.
Put some heatshrink over wires when they’re soldered to pins and other connectors. Make sure the amount of live exposed metal is kept to a minimum.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How are the materials used in PCB manufacturing recovered and recycled?

We are seeking a way to develop sustainability of our product, but it seem not so hard to deal with some product parts such as PCB and its component. How are the materials used in PCB manufacturing recovered and recycled?

Oliver Smith October 11, 2023

Do modern LED lights use thermal vias?

I have a technical question about thermal management with mid-power LED diodes.Do you use thermal vias on the PC board anymore? Either under the LED diode footprint or even around the footprint?
Depends on the application limits and cost targets.

Oliver Smith October 30, 2023

What SMT assembly techniques should I employ for a small PCB with only a one SOIC ?

So I’m going to repackage this breakout module for simple SPI with a bus-powered LED light strip. It seems expensive and unnecessary for advanced SMT assembly equipment and since its a small PCB with only a few SMDs. What techniques should I employ for this simple SMT assembly?

Oliver Smith November 23, 2023