How can I find adapters that can fit my uncommon module?

I have an IC that is 30mm*30mm*2.9mm quad flat package with 80 castellated pins. It is not a common type. How can I find adapters that can fit my uncommon module?

We suggest to get a custom service. Unless the manufacturers of the module provide a breakout board, I doubt that you will be able to find an off-the-shelf adapter. Manufacturers of modules usually provide development boards.

Read More: Supplier Chain Management

#PCB Assembly

Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.
Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

What Others Are Asking

Is solder mask a valid electrical insulator?

There is a copper pour over the entire top of the my PCB, which is part of GND net. It turns out that the surface mounted 1W LEDs I’m going to use have the heat slug connected internally to the LED’s +ve terminal. Can I rely on the solder mask to insulate the +ve voltage (~3V ish) from GND? Long term?

How can I mount a pulse oximeter on the surface of PCB without putting too much stress?

The PCB has a pulse oximeter mounted on the surface, and it’s tolerance is 0.6mm. The problem is the pulse oximeter needs to touch the bottom case at all times. How to best mount the PCB in the case without putting too much stress on the pulse oximeter? Will screws with flexible washers be all right? Sadly separating pulse oximeter from main PCB is not an option.

Read Detailed Advice From Blog Articles

Scroll to Top