Which soldering iron tip should I use?

All of the soldering I've done to this point has been with through-hole components. I hope to move up to some smaller surface-mount parts at some point in the future. I've got a Weller WES51 soldering station. There is a large number of ET series tips available. How do I choose the right tip for the components I'll be working with?

PCB Assembly
December 13, 2023

You can, in fact, solder a 0.4mm pitch TQFP with a tip that spans several pins, such as the ETA you mention, but it takes a lot more skill and flux.If you’re doing mostly through-hole components, the ETA is perfectly fine.
I’m also doing SMT and very fine SMT work, so I also purchased the 0.030″ and 0.015″ conical tips. I use these under a microscope to do the 0.4mm (about 0.016″) pitch TQFP chips.
It is worthwhile getting the biggest chisel tip you can, as well, for the occasional need to deal with soldered heat sinks or parts soldered to ground planes or PCB heat sinks. These can pump all 40+ watts of your iron into the joint, allowing you to remove it without heating the component up too much.

Remark: Keep in mind that typical wet sponge tip cleaners can lower the tip’s temperature significantly, especially with the small tips.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

What do I need to build my quadcopter PCB, from project to manufacturing?

We are an company in the field of electronic products. This quarter we are going do start a drone project, which is a completely new field for us. We want to know about how to move on.

Oliver Smith October 11, 2023

Does anyone have any experience using zero-ohm resistors in an RF signal path to select antennas?

I’ve typically used RF switches for this purpose, but that’s also when it was necessary to allow the antenna selection to be changed “in the field”. But for cases where the antenna selection is a manufacture-time option, I’m considering simple zero-ohm resistors.

Oliver Smith December 6, 2023

Why the PCB is cold, but LED bulbs are still hot?

I have a THERMAL problem when designing a power LED ALUMINUM PCB. I have 10 5W UV power LEDs.Coldwater flows through water heat sink continuously. The problem is the PCB is cold, but LED bulbs are still hot? Can anyone give me some advice.

Oliver Smith October 27, 2023