How do you draw pin grid array in cadsoft Eagle PCB?

I'd like to use a processor that uses a pin grid array. Basically, I'd like to make the prototyping PCB board for it. I'm new to eagle. How can I connect the inner PGA pins to the header pins on the edge (without shorting the lines)?

PCB Design
November 30, 2023

Try not to make so long because your outer pinout is sensible. you should be able to do most of this on one layer. With a standard 5 mil trace/space process, you should have no problem fitting a trace between two pads. It should be possible to route that whole thing on one layer.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How to find a datasheet for a part that doesn’t exist on the manufacturer’s website?

While bored recently, I decided to take apart a few old pieces of electronic equipment and attempt to reverse-engineer them. I’ve been doing pretty well, but I’ve come to an IC that I can identify but doesn’t seem to exist on the manufacturer’s website.

Oliver Smith October 24, 2023

Why should we bake bare PCB?

The assembly note states: Bake bare PCBs in a clean and well ventilated oven prior to assembly at 125*C for 24 hours. Why is this necessary?

Oliver Smith November 2, 2023

What do I need to build my quadcopter PCB, from project to manufacturing?

We are an company in the field of electronic products. This quarter we are going do start a drone project, which is a completely new field for us. We want to know about how to move on.

Oliver Smith October 11, 2023