How can I handle missing solder mask opening on PCB footprint?

I have three through-hole PCBs that are missing front and back solder mask openings for two of the components. The solder mask (usually green) is covering the front and back solder pads. All other pads for all other parts are exposed. Is there a good way to remove the solder mask so that I can solder the components to the board?

PCB Assembly
November 27, 2023

You can use a burnishing pen, scratch brush, or fiberglass pen. It looks like an eraser pen but has fiberglass brush bristles come out. It’s much more precise, gentle, and safe than a knife, dremel, or sandpaper. Just pretend it’s an eraser. Normally used to scrape away oxidiation and rust.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Why are there swirls or zig-zag lines on the PCB samples?

I send my PCB design to manufacturer for prototype, but they send back deviated PCB samples with additional zig-zag. Why are there zig-zag lines on it? Reducing interference?

Oliver Smith October 11, 2023

What’s the benefit of outsourcing my PCB layout?

We are a trading company with a heath care brands. We just hesitate about whether design the medical device PCB by ourselves or outsource the design.

Oliver Smith November 9, 2023

Which soldering iron tip should I use?

All of the soldering I’ve done to this point has been with through-hole components. I hope to move up to some smaller surface-mount parts at some point in the future. I’ve got a Weller WES51 soldering station. There is a large number of ET series tips available. How do I choose the right tip for the components I’ll be working with?

Oliver Smith December 13, 2023