Can I design SMD elements on the back of THT?

I'm designing a PCB right now and found out I can save a lot of space using the back of THT elements. Is it legit to design like that? Are there any problems that might occur?

PCB Design
November 24, 2023

If you want to meet CE requirements for noise immunity and emissions, a two-layer board would help a lot.

Generally speaking, there is no problem with putting components on both sides of the board, in the same place. If you had a two (or more) layer board, you’d probably want to put a ground or power plane between them. However, you can’t do that with a single-layer board. So you should watch out for a fast digital chip interfering with an analog circuit. It would be inadvisable.

For example, put a microcontroller on one side and a high input impedance buffer on the other. But putting decoupling caps opposite the chip is probably a good plan.

#PCB Design

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Are the two modules interfering with each other in a PCB with GSM module and the gp-635t GPS?

In my current prototype, I have a SIMCOM GSM module and the gp-635t GPS. They are both in an enclsoure including antennas (gps antenna is integrated). What I experience is sometimes poor GSM and GPS connectivity and sometimes GPS doesn’t get any fix (in the 2 minutes of time i allocate for it) and the GSM fails to send data sometimes. Any tips on this case?

Oliver Smith November 29, 2023

Is it true that PCB antennas can be tuned by only changing their length?

My PCB antennas fail to achieve resonance, though I have changed their length. Our new product project is obstructed due to this problem now. Are there any good solution else?

Oliver Smith November 14, 2023

How can I electrically isolate a PCB from a heat sink?

I have a set of LED driving lights for motorcycle that must be wired through a ground-leg pulse width modulation dimmer. The problem is the mounting bracket for the lights is grounded, so the lamp shorts to ground through the motorcycle chassis and the PWM dimmer cant dim the lamps. How do I handle this problem?

Oliver Smith December 5, 2023